Structural health monitoring for telecom towers and masts
Tilt and vibration monitoring follows foundation movement and changes in tower behaviour remotely, so site visits can be planned where the data shows a change.
Request a quote
Why monitor a tower
Lattice towers and monopoles are light, slender and exposed to wind, and many stand on remote sites. Uneven foundation settlement shows as tilt; changes in the structure or its connections show as changes in vibration. In seismic regions, earthquakes add a further load. All of these can be followed without a site visit.
Remote sites
Struct-Gate, the StructHEALTH gateway with a SIM card, sends data to the Healthy Structures IoT Platform over the mobile network. Alarm limits are set on the platform, so maintenance visits can be prioritised by measured change.
What is measured
Products that can be used in this solution

Struct-Tilt
MEMS inclinometer, 0.005° resolution

StructSense
Four three-axis nodes, 25 to 0.02 µg/√Hz noise density

Healthy Structures IoT Platform
Analyses, alarms, reports and modal analysis
Monitoring data supports the structural engineer's assessment. Decisions about the condition of a structure remain with the engineer.
