Structural health monitoring for wind turbine towers and foundations
Tower vibration and foundation tilt, followed over time, show changes in a turbine's structure early and tell the operator which towers to inspect first after a storm or an earthquake.
Request a quote
Why monitor the tower and foundation
A wind turbine tower works under cyclic wind and rotor loads for its whole service life. Excessive tower vibration contributes to fatigue, and foundation problems show up as tilt. Tracking the tower's natural frequencies and the foundation's tilt over time reveals changes before they become visible.
After a storm or an earthquake
On a wind farm with many turbines, the operator needs to know which towers to inspect first. Comparing each tower's measurements before and after the event gives a starting order for inspection, based on data from every instrumented tower.
What is measured
The system monitors the tower and foundation structure. It does not replace the turbine manufacturer's condition monitoring of the drivetrain.
Products that can be used in this solution

StructSense
Four three-axis nodes, 25 to 0.02 µg/√Hz noise density

Struct-Tilt
MEMS inclinometer, 0.005° resolution

Healthy Structures IoT Platform
Analyses, alarms, reports and modal analysis

Stress and strain sensors
Strain gauges, load cells and pressure cells
Monitoring data supports the structural engineer's assessment. Decisions about the condition of a structure remain with the engineer.
